top of page

INNOVIS CORP

All Innovis Corporation are designed for superior performance with minimal effort required on the part of the installer. They provide maximum flexibility and are engineered to meet and exceed the standards set by many industry related organizations. Expensive waterproofing systems have all been eliminated. Innovis does all of this while providing cost effective “off the shelf” value to the installer.

INNOVIS BETTERBENCH

Innovis Better-Bench™  is an easy to install bench-forming system that replaces the complex methods currently in use. This fully independent supporting unit can be mounted to most vertical surfaces quickly and efficiently, saving the installer valuable time. What once took days can now be done in about an hour!

  • Engineered 400 lb load capacity on all bench products. 100 lb load capacity on the Better Tray (BT-17)

  • Install before or after finish tile is applied to vertical surfaces.

  • Self-supporting, one piece frame is easy to install with supplied fasteners, requiring no additional waterproofing or structural reinforcement.

  • Use in wet or dry locations; mount over any U.B.C. approved substrate material.

  • Takes only minutes to mount, place mortar mix (sand & cement), and tile as desired.

  • Long lasting and corrosion resistant materials throughout.

The Innovis Better-Bench™  is manufactured in the U.S.A.

Products listed below are produced of an alloyed aluminum and are sent as one piece. All products are supplied with hollow wall anchors and wood screws. Fastening to studs, blocking, or other framing members is not required. If framing members are encountered, discard hollow wall anchor and use provided screw with an appropriate pilot hole.

bottom of page